Solar Panel Removal Service and Reinstallation in Orange County
Panels often outlast the roof they sit on. When the roofing underneath reaches the end of its life, the array has to come off before anyone can touch the deck. Our solar panel removal service covers that whole sequence, from the first disconnect to the final reset.
OC Roof Kings handles both halves of solar panel removal and reinstallation across Orange County. Our own crew takes the array down, we do the roof work with the deck open, and the same crew puts the panels back. Family-owned and operated. Licensed and insured. More than 20 years.
When the roof under your array needs work
Three situations bring this up, and all three end the same way. Your roof ages out while the panels still produce well. A leak sits underneath the array where nobody can reach it. Or other roof work needs the space the panels currently occupy.
In each case, the panels come off first. Nobody can reroof reliably around a fixed array, and a patch near the mounting feet rarely holds for long. Therefore, the array moves, we do the roof properly, and the panels go back afterward on a sound deck.
Not sure whether the roof under your panels needs work yet? A roof inspection answers that before you commit to anything. We check the deck, the flashing, and the condition around every mounting foot. Then we tell you what we actually find up there.
How our solar panel removal service works
Every job runs as a detach and reset, so the order matters more than the speed. Our solar panel removal service follows the same four steps each time. An array that goes back approximately instead of exactly becomes a leak two winters later.
Documenting the array before anything moves
We photograph the layout, label the connections, and record where every mounting foot sits. Consequently, the array returns to its original positions rather than close ones. That same record tells us which roof penetrations need new flashing once the deck sits open.
Taking the panels down
Our own crew handles the disconnect and the takedown. We lift the panels off first, then the racking and the mounting hardware. After that, we stage everything on the ground where nobody steps on it. Nothing stays on the roof while the roof work runs.
Roof work with the deck open
With the array clear, your roof gets the same treatment as any other roof. We remove the failed roofing, lay new underlayment across the plane, and install new flashing at every old penetration. That last part matters, because old mounting holes are exactly where water finds its way in.
Resetting and reconnecting
The racking goes back first, seated on new flashing at each foot. Then the panels return to their recorded positions, and our crew reconnects the system and confirms it powers back up. We leave once the array runs again, and you see it working before the crew packs up.
Remove and reinstall solar panels for a new roof
The most common version of this job is a full roof replacement beneath an existing array. The panels still produce fine, but the roofing under them has aged out. New roofing under old flashing defeats the whole point of the work, so the flashing changes too.
Doing both together keeps the timeline tight. One schedule, one crew, one point of contact. Otherwise, a solar company handles the panels while a separate roofer handles the deck. That gap is where your array sits off the roof far longer than it needs to.
Detach and reset without a full reroof
Not every homeowner needs a new roof to need the panels moved. Solar detach and reset also runs as its own job, whether a repair sits under the array or other work needs the space. You get the same four steps and the same crew, just without the full reroof in the middle.
Leaks near an array usually trace back to the mounting penetrations rather than the field of the roof. So when a leak shows up, we lift only what we need to reach the fault. Both roof repair and roof leak repair run that way, and we check every mounting foot before we blame the shingles.
Leased and PPA solar systems
If you lease your system or buy power under a PPA, the solar company still owns the equipment on your roof. Before we touch it, we confirm the solar company allows a third party to detach and reset the array. That check comes first on every leased or PPA job.
Consequently, nobody finds a contract problem halfway through the work. If you own your panels outright, that step drops away and we schedule directly with you. Either way, you know where the paperwork stands before the first panel comes down, and the roof work stays on track.
Tile, shingle, and low-slope roofs
Roof type changes the takedown more than it changes the reset. Tile roofing needs the tile lifted and stacked before the racking comes off, and we replace broken pieces rather than reusing them. Asphalt shingle roofing comes apart faster, though it shows every old mounting hole.
Low-slope roofs need their own approach again, since the mounting and the drainage sit differently. So we read the system on site before we plan anything. The approach for your roof follows what we find up there, rather than arriving ready-made from a template.
One crew for the roof and the panels
Roof work under solar usually means two companies. A roofer who will not touch the array, and a solar crew who will not touch the deck. That split is exactly where the schedule slips and where each side points at the other when something goes wrong.
We take that split out of the job. Our own people handle the disconnect, the takedown, the roofing, and the reset. As a result, one solar panel removal service call covers the whole job, and your panels spend the shortest practical stretch off the roof.
Solar panel removal service across Orange County
We provide solar panel removal services across Orange County. Newer tract neighborhoods often have arrays that came with the house, while older homes tend to carry panels added onto aging roofs. Our crews work in Irvine, Anaheim, and Yorba Linda, and we cover the rest of the county from the same shop.
Solar work sits inside our full residential roofing range, and our complete roofing services list covers every system we work on. Browse the full service areas list to see where our crews go. Anywhere in the county, the same crew handles both halves of the job.
Frequently Asked Questions
Yes, but the panels have to come off first. Nobody can replace roofing underneath a fixed array, and working around it leaves the worst part of the roof untouched. We take the array down, replace the roof across the full plane, and then reset the panels.
For a full replacement, yes. For a small repair away from the array, often no. The deciding factor is whether the work sits under the panels or clear of them. We tell you which one applies after we look at the roof in person.
Ours do. Our own crew handles the disconnect, the takedown, and the reset, rather than passing that half of the job to a separate company. That keeps one schedule and one point of contact from the first disconnect through the final reconnection.
The takedown itself is the short part of the job. The roof work underneath sets the real schedule, so array size and roof condition both matter. We give you the sequence in writing before we start, so you know when your system goes back online.
They come off, sit staged on the ground, and go back onto the finished roof. We document the layout first and label the connections, so each panel returns to its recorded position. New flashing goes in at every mounting point before the racking returns.
Schedule your solar panel removal service
Call (949) 561-2069 or send us a message. We look at the roof under your array, tell you what it needs, and put the scope in writing before any work starts. Homeowners across Orange County rate us 5 stars on Google. We hold California Contractor License #600662.
Family-owned and operated. Licensed and insured. More than 20 years.
